This instruction sheet provides termination requirements for the NECTOR S Bus Bar Connector. It details the process for cable termination, ensuring proper seating and alignment for successful connection. For additional application information, refer to Application Specification 114-20131.
| Feature | Description |
| Product Name | NECTOR S Bus Bar Connector |
| Tooling Assistance Center | 1-800-722-1111 |
| Product Information | 1-800-522-6752 |
| Website | www.te.com |
| Instruction Sheet Number | 408-32179 Rev A |
| Application Specification Number | 114-20131 |
| Recommended Hand Tool | TE hand tool (p/n 8-528441-7) |
| Alternative Termination Tool | Tool with parallel type action (e.g., arbor press) |
| Cable Carrier Removal | Gently pry off using two small screwdrivers to avoid damaging locking tabs. |
| Cable Positioning | Lay cable flat inside the cable carrier channel. Ensure cable surface is aligned to the cover surface. For end type bus bar connectors, push cable against the end stop of the cable carrier. |
| Cable Polarity Convention | Striped/ribbed side of cable normally placed on Neutral (N) or Negative (-) side of the bus bar connector. |
| Termination Process | Pre-form cable to fit support fixture. Route cable through support features in hand tool. Place pre-staged connector into TE hand tool and squeeze handles fully. |
| Termination Inspection | Inspect all latch features on housing body and cable carrier to ensure they are fully seated. Verify cable is flat in the termination area. Terminated connectors are not repairable. |
| Unsupported Termination Method | Standard single pivot type hand pliers. |
