This section details the electrical, mechanical, and environmental performance characteristics of the product, ensuring reliability and durability under various operating conditions.
| Item | Test Condition | Requirement |
|---|---|---|
| Contact Resistance | Mate applicable FPC/FFC and measure by dry circuit, 20mV MAX, 10mA. | < 20 m MAX |
| Insulation Resistance | Mate applicable FPC/FFC and apply 500V DC between adjacent terminal or ground. | 500 M MIN |
| Dielectric Strength | Mate applicable FPC/FFC and apply 200V AC (virtual value) for 1 minute between adjacent terminal or ground. | No Breakdown |
| Locking and Withdrawal Force | Insert and extract applicable FFC at the speed rate of 25 3mm/minute. | Insert: 1.96*n (N) MAX Withdrawal: 0.49*n (N) MIN |
| Terminal Retention Force | Pull the terminal at the speed rate of 25 3mm per minute. | 392N MIN |
| Repeated Insertion and Withdrawal | Actuator up to 20 cycles at the speed rate of less than 10 cycles/minute. | Contact Resistance: 60 m MAX |
| Temperature Rise | Carrying rated current load. (UL 498) | 30 C MAX |
| Appearance | Shock & Vibration Test (Details in source text) | No Damage |
| Appearance | Heat Resistance Test (852C, 96 hours) | No Damage |
| Appearance | Cold Resistance Test (-402C, 96 hours) | No Damage |
| Appearance | Humidity Test (402C, 90-95% RH, 96 hours) | No Damage |
| Appearance | Temperature Cycling Test (-553C to 852C, 5 cycles) | No Damage |
| Appearance | Salt Spray Test (352C, 51% solution, 24 hours) | No Damage |
| Appearance | Soldering Heat Test (2455C) | No Damage |
| Appearance | SO2 Gas Test (402C, 505ppm SO2 gas, 24 hours) | No Damage |
| Appearance | NH3 Gas Test (Evaporating from 28% Ammonia solution) | No Damage |
| Solder ability | Soldering Time: 20.5 sec. Soldering Temperature: 2455C 0.2 mm from terminal tip | Solder Wetting 95% |
| Resistance to Soldering Heat | Soldering Time: 305 sec. Soldering Temperature: 2455C | Appearance: No Damage |
| Item | Test Condition | Requirement |
|---|---|---|
| Vibration | 10-55-10Hz/min, Amplitude: 1.5mm P-P, Sweep time: 1 minute, Duration: 2 hours in each X,Y,Z axes. | Contact Resistance: 60 m MAX Discontinuity: 1 ms MAX. |
| Shock | 490m/s {50G}, 3 strokes in each X,Y,Z axes. | Appearance: No Damage Discontinuity: 1 ms MAX. |
| Electrical Strength | (Details in source text) | Must meet 4.1.3 Insulation Resistance 20 M MIN |
