Scope: This specification covers the PH series connectors.
Product Name: Wire-to-Board Connector
Wire-to-Board Connector
PH Series
| Item | Requirement | Unit |
|---|---|---|
| Rated Voltage [AC(rms)/DC] | ||
| Rated Current | 2 | A |
| Ambient Temperature Range | -20 to +85 |
| Electrical Performance | Requirement | Unit |
|---|---|---|
| Contact Resistance | ≤20 | m |
| Insulation Resistance | ≥100 | M |
| Dielectric Strength | 500 | V AC/minute |
| Mechanical Performance | Requirement | Unit |
|---|---|---|
| Male Contact Retention Force (PIN) | ≥15 | PER PIN |
| Female Contact Retention Force (Terminal) | ≥15 | PER PIN |
| Plug-in Force | ≤0.5 | N PER PIN |
| Plug-out Force | ≥0.2 | N PER PIN |
| Environmental and Other Performance | Test Condition | Requirement | Unit |
|---|---|---|---|
| Repeated Insertion and Withdrawal | Insertion and withdrawal actuator up to 20 cycles at the speed rate of less than 10 cycles/minute | Contact Resistance: MAX 20 | m |
| Vibration Resistance | DC 1mA energized; Amplitude: 1.5mm P-P; Sweep time: 10-55-10Hz in 1 minute; Duration: 2 hours in each X, Y, Z axes | Appearance: No Damage; Contact Resistance: MAX 20; Discontinuity: MAX 1 | m, ms |
| Shock Resistance | DC 1mA energized; 490m/s {50G}, 3 strokes in each X, Y, Z axes | Appearance: No Damage; Discontinuity: MAX 1 | ms |
| Heat Resistance | 852, 96 hours | Appearance: No Damage; Contact Resistance: MAX 30 | m |
| Cold Resistance | -402, 48 hours | Appearance: No Damage; Contact Resistance: MAX 30 | m |
| Solderability | Soldering Time: 20.5 sec; Soldering Temperature: 2455; 0.2 mm from terminal tip | Solder Wetting: ≥95% | % |
| Resistance to Soldering Heat | Soldering Time: 30.5 sec; Soldering Temperature: 2605; 0.2 mm from terminal tip | Appearance: No Damage, Deformation | |
| Endurance (Action) / Durability (Life) | Rated current: 1A; Endurance with loading: 500 cycles at a speed of 15-18 cycles/min | Contact Resistance: MAX 50 | m |
