This document details the specifications for a connector designed in accordance with the Universal Serial Bus Type-C Cable and Connector Specification Revision 1.2. It is intended for applications requiring high-speed data transfer and power delivery. The design emphasizes robust construction and precise mating dimensions for reliable system integration.
| Part/Model | Description | Qty. | Material | Finish | Remarks |
| SUB ASSEMBLY INSERT MOLD | HEAT RESISTING PLASTIC | 1 | COLOR:BLACK | ||
| MID PLATE INSERT MOLD | HEAT RESISTING PLASTIC | 1 | COLOR:BLACK | ||
| CONTACT A | COPPER ALLOY | 12 | CONTACT AREA: NICKEL:1m MIN GOLD :0.1m MIN | SOLDER TAILS: GOLD FLASH OVER NICKEL | |
| CONTACT B | COPPER ALLOY | 12 | CONTACT AREA: GOLD OVER NICKEL | SOLDER TAILS: GOLD FLASH OVER NICKEL | |
| MID PLATE | STAINLESS STEEL | 1 | NICKEL PLATING | ||
| SHELL | STAINLESS STEEL | 1 | THE SHELL LENGTH IS LESS THAN THE MINIMUM SPECIFIED BY THE USB TYPE C STANDARD. AS SUCH IT CANNOT INDEPENDENTLY BE GURANTEED TO MEET ALL TYPE C MECHANICAL REQUIREMENTS. THE SYSTEM IMPLEMENTER IS RESPONSIBLE FOR ACHIEVING PRODUCT RELIABILITY AND PASSING USB COMPLIANCE TESTING. REFERENCE THE USB TYPE C SPECIFICATION RELEASE 1.2, SECTION 3.2.1, NOTE 7. | ||
| GASKET | SILICONE RUBBER | 1 | COLOR:RED | VACUUM AREA. | |
| REAR SHIELD | STAINLESS STEEL | 1 | NICKEL PLATING |
| Pin No. | A1 | A2 | A3 | A4 | A5 | A6 | A7 | A8 | A9 | A10 | A11 | A12 |
| Signal | GND | TX1+ | TX1- | VBUS | CC1 | D+ | D- | SBU1 | VBUS | RX2- | RX2+ | GND |
| Pin No. | B12 | B11 | B10 | B9 | B8 | B7 | B6 | B5 | B4 | B3 | B2 | B1 |
| Signal | GND | TX2+ | TX2- | VBUS | CC2 | D- | D+ | SBU2 | VBUS | RX1- | RX1+ | GND |
NOTE 1: COPLANARITY OF SMT TERMINAL BE 0.1 MAXIUM.
NOTE 2: THIS FACE IS DATUM PLANE.
NOTE 3: MATING DIMENSIONS CONSIST OF "Universal Serial Bus Type-C Cable and Connector Specification Revision 1.2".
NOTE 4: THE SHELL LENGTH IS LESS THAN THE MINIMUM SPECIFIED BY THE USB TYPE C STANDARD. AS SUCH IT CANNOT INDEPENDENTLY BE GURANTEED TO MEET ALL TYPE C MECHANICAL REQUIREMENTS. THE SYSTEM IMPLEMENTER IS RESPONSIBLE FOR ACHIEVING PRODUCT RELIABILITY AND PASSING USB COMPLIANCE TESTING. REFERENCE THE USB TYPE C SPECIFICATION RELEASE 1.2, SECTION 3.2.1, NOTE 7.
NOTE 5: METAL EXPOSED AREA SIZE COULD BE SLIGHTLY CHANGED BASED ON MOLDING PROCESS CONDITION IN EACH LOT, HOWEVER THIS WOULD NOT AFFECT CONNECTOR FUNCTION.
NOTE 6: VACUUM AREA.
NOTE 7: PIN ASSIGNMENT (FRONT VIEW
NOTE 8: LOT NO. IS MARKED AS SHOWN IN BELOW TABLE.
NOTE 9: THE P.C.B. LAYOUT IS ONLY FOR REFERENCE. ACTUAL PCB DESIGN (INCLUDING DIMENSION AND TOLERANCE) IS SUPPOSED TO BE INVESTIGATED BY DEVICE MANUFACTURER.
