The FH35C Series is a 0.3 mm pitch, 0.9 mm height, back flip type dual-sided FPC connector designed for high-speed transmission and improved FPC retention. It offers design flexibility by utilizing both top and bottom contacts, enhanced retention force through a proprietary contact structure and back flip actuator, and excellent impedance characteristics for high-speed applications like eDP (ver1.3) and MIPI (D-PHY). Delivered with the actuator open to reduce installation time, it features tapered guides for easy FPC insertion and is compatible with 0.2mm thick FPC. The bottom side is over-molded for contact protection, allowing for additional PCB patterning underneath. This connector is halogen-free and compatible with automatic mounting via tape-and-reel packaging.
| Attribute | Specification | Conditions |
|---|---|---|
| Current Rating | 0.2 A (Note 1) | |
| Voltage Rating | AC 30 Vrms | |
| Operating Temperature Range | 55 to +85C (Note 2) | 90% or less of relative humidity (No dew condensation) |
| Storage Temperature Range | -10 to +50C (Note 3) | 90% or less of relative humidity (No dew condensation) |
| Insulation Resistance | No less than 50 M | Measured at 100 V DC |
| Withstand Voltage | No flashover or breakdown | 90 V AC for one minute |
| Contact Resistance | 100 m MAX. (Including FPC conductor resistance) | AC 20 mV MAX (1 KHz), 1 mA |
| Mating Cycles | 10 times | Contact resistance: no more than 100 m; No breakage, cracks, or loosened parts |
| Vibration Resistance | At the frequency of 10-55 Hz, half amplitude 0.75 mm, 10 cycles in each of three axial directions; No electric outage of 1 s or greater; Contact resistance: no more than 100 m; No breakage, cracks, or loosened parts | |
| Shock Resistance | Acceleration: 981 m/s; Duration: 6 ms, sine half-wave, 3 cycles in each of the 3 axis each in both directions; No electric outage of 1 s or greater; Contact resistance: no more than 100 m; No breakage, cracks, or loosened parts | |
| Humidity Resistance (Steady State) | Left to stand for 96 hours at 40C and 90% to 95% humidity; Contact resistance: no more than 100 m; Insulation Resistance: 50 M or more; No breakage, cracks, or loosened parts | |
| Temperature Cycles | Temperature: -55 +15 to +35 +85 +15 to +35C; Time: 30 2 to 3 30 2 to 3 minutes; 5 cycles; Contact resistance: no more than 100 m; Insulation Resistance: 50 M or more; No breakage, cracks, or loosened parts | |
| Solder Heat Resistance | No deformation in appearance or marked instability of contacts | Reflow: According to Recommended Temperature Profile; Manual soldering: 35010C for 51 sec. |
